This section describes how to control an inverter that has been connected to the NetEco 1000S, including powering on and off the inverter, restarting the inverter and starting the arc-fault circuit interrupter (AFCI) self-check.
- You have logged in as the installer who has been assigned the device remote control permissions.
- You have added a device to the NetEco 1000S and the device state is normal.
- Control one inverter:
Choose Monitor > Select the target inverter in the navigation tree on the left > Details tab in the operation display area
Power ON the inverter
Power OFF the inverter
Start the AFCI self-check
Restart the inverter
- Power on or off all inverters in the same plant or SmartLogger in batches:
Choose Monitor > Select the target plant in the navigation tree on the left > Click the Settings tab in the operation display area > Remote control Power ON all inverters
Power OFF all inverters
- Or you can control all inverters on the Smart Logger level. To perform this action select the needed Smart Logger on the left side and go to Settings > Remote control